• 2-23 • RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures
Installing the Edge Guide Assembly
1. Insert the Edge Guide Assembly into the printer frame making sure the two
notches on either end of the Media Plate Guide (p/n CA18552-1) line up with the
corresponding plastic tabs on the Lower Housing. (See arrows in photo below.)
2. Insert the screw on the bottom of the printer to secure the Edge Guide
Assembly to the printer frame.
3. Install Upper Housing onto Lower Housing with the seven screws described
previously.
4. Install the battery.
continued on next page
To Next Page
Loading...
