RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures • 2-42 •
4. Align the keypad housing with the two mounting holes on the Upper Housing
and secure from the back with two screws.
5. Reattach the Upper Housing by aligning the mounting holes on both side
arms of the Upper Housing to the mounting holes on the side of the printer
above the gear retainer cover and next to the latch release button.
6. Secure the Upper Housing to the printer frame using the two (2) screws
located above the two antenna boards.
7. Reconnect the antenna cables to the appropriate antenna boards as shown
below. (Only the 802.11G cable is secured with the clip as the ferrite beads on
the Bluetooth cable prevent it from being secured.)
8. Re-install the Main Logic Board as described previously on Page 2-36.
9. Secure the Upper Housing to the Lower Housing with the five screws on the
bottom of the printer and two screws under the media cover.
To Next Page
Loading...
