Zebra P4T Installation Guide

19
P4T Vehicle Cradle Installation Guide
into the bottom of the Cradle.
• Route the input power cable out of the Cradle. Note that it
can be routed out either side of the Cradle and that there are
retaining features in the Cradle to keep the cable in place.
Refer to Figure 3.
• Be sure to leave enough slack in the power cable to allow
the Mounting Arm to pivot freely without putting strain on
the power connections.
• Make sure that the input power cable routing does not in-
vite damage to the cable when the Vehicle Cradle is pivoted.
Once the cable routing has been determined, secure it to the 3.
Vehicle Cradle with the cable clamp(s) supplied with the in-
stallation kit. Use the self-tapping screws and fl at washers
supplied in the kit to attach the clamp to the Cradle.
Secure one of the mounting fl anges from the movable Arm to 4.
the bottom of the Vehicle Cradle with the (4) #10-32 or #10-
24 screws supplied with the Mounting Arm.
Secure the other mounting fl ange on the Movable Arm to 5.
the desired mounting surface. You can use the #10-24 x 3/4”
screws and associated hardware supplied in the Mounting
Arm Kit or use other hardware as the mounting conditions
dictate.
Input Power Completion
Route the input power cable per the earlier section in this Guide:
“Input Power Cable Completion.”

Zebra P4T Specifications

General

Color	No
Maximum resolution	203 x 203 DPI
Core diameter	19 mm
Ribbon length	29992.3 m
Media thickness	0.08 - 0.22 mm
Maximum roll diameter	66 mm
Media thickness (imperial)	0.0032 - 0.0085 \
Bluetooth	Yes
Connectivity technology	Wireless
Battery capacity	4200 mAh
Weight (imperial)	2.9 lbs
Dimensions (WxDxH)	165.9 x 85.9 x 220.5 mm
Flash memory	8 MB
Internal memory	16 MB
Built-in barcodes	Code 39, Code 93, MaxiCode, QR Code, UPC-A, UPC-E
Page description languages	CPCL-native, EPL, EPL2, XML, ZPL
Storage temperature (T-T)	-22 - 149 °F
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Package weight	1900 g