Zebra R110Xi HF - Guideline Data - Smartrac Transponders

RFID TRANSPONDER PLACEMENT /
POWER GUIDELINES
DISCLAIMER
THE INFORMATION CONTAINED IN THIS GUIDELINE IS SUBJECT TO THE WARRANTY DISCLAIMERS, LIMITATIONS
OF LIABILITY AND INDEMNIFICATION PROVISIONS CONTAINED IN THE ZEBRA TECHNOLOGIES CORPORATION
INLAY GUIDELINES TERMS OF USE. SUCH TERMS OF USE MAY BE FOUND AT WWW.RFID.ZEBRA.COM/
TRANSPONDERSPECS. USERS SHOULD ALWAYS TEST THE RFID TRANSPONDER AND LABELS FOR SUITABILITY
IN THE INTENDED APPLICATION PRIOR TO MAKING ANY MATERIAL OR EQUIPMENT PURCHASES. THE
GUIDELINE IS SUBJECT TO CHANGE WITHOUT NOTICE.
©2015 ZIH Corp. All Rights reserved. www.zebra.com
Model Number: HXX-7XX-XXXXX
Zebra R110Xi HF
Guideline
#
Revision
Date
Protocol
Transponder Transponder Placement (mm) Printer/ Encoder Settings
Manufacturer
Manufacturer
Part Number
Orientation
a x y
Tag
Type
Antenna
Port
RFID
Power
Option
Viewed through facestock/
Machine direction down
Option (± 3mm) (± 3mm) ()
0021 9/26/2012 ISO 14 443 A Smartrac 3002222
Circus
A
A 13 21 48 14443A 2 HIGH
0022 9/26/2012 ISO 14 443 Smartrac 3002225
MiniTrack
A
A 13 23 42 14443A 2 HIGH
0023 9/28/2012 ISO 14 443 Smartrac 3002221
MiniTrack
A
A 25 24 52 14443A 2 HIGH
0024 10/05/2012 ISO 14 443 Smartrac 3002221
MiniTrack
A
A 25 24 42 14443A 2 LOW
0025 8/29/2014 ISO 15 693
Smartrac
3002974
MiniBlock
A
A 13 26 50
15693
1 LOW
0026 12/22/14 ISO 15 693 Smartrac
3001922
RaceTrack
A
A 26 4 90- 15693 2 LOW
TRANSPONDER PLACEMENT/ POWER GUIDELINES
Zebra R110Xi HF
Printer/ Encoder
Page
6 of 6