Zebra Stripe - AC Power Cable Selection

8 Appendix
In thi s se ction. .. Page
AC Power Cable Selection..................................................................8-1
Cable Requirements......................................................................8-1
110 VAC Applications ..................................................................8-1
220 VAC Applications ..................................................................8-1
ASCII Code Chart ................................................................................8-2
Setting Print Darkness .........................................................................8-3
AC Power Cable Selection
Cable Requirements
The AC Power Cable has a three-prong female connector on one end. This
Connector must be plugged into the mating connector on the left side of the
Zebra Stripe Printer. See Figure 8.2.
110 VAC Applications
A Standard US style three-prong grounded male plug is attached to the other end
of the AC Power Cable. This connector must be plugged into a nearby electrical
outlet.
220 VAC Applications
The power cord may or may not have a male AC plug attached. The proper
grounded AC power plug must be obtained and installed by the user. The cable
must then be plugged into a nearby electrical outlet.
Part Number AC Power Cable Description
44618 Detachable Power Cord (US Standard 3-Prong Plug - 110 VAC)
44629 Detachable Power Cord (Continental Europe 3-prong plug - 220 VAC)
44637 Detachable Power Cord (British 3-prong Plug - 220 VAC)
Figure 8.1 AC P owe r Cabl e
44868L 8-1