Loading Roll Media
When you load media, you must place the roll on the media hangers and
then adjust the media guides.
You must use the correct media for the type of printing you require. When
printing without a ribbon, you must use direct thermal media. When using
ribbon, you must use thermal transfer media. The printer's ribbon sensor
detects motion of the supply spindle.
Adjusting the Roll Holders
Check the core of the media roll and
adjust the holders if necessary.
— For a narrow core, lift the adjusters
up.
— For a wide core, press the adjusters
down
980485-001A 9
MOVIE
MOVIE
To Next Page
Loading...