Connecting the Printer to Power
Never operate the printer and power supply in an area where they can get wet. Serious
personal injury could result!
1. Turn your printer off - make sure the power switch on the back is down.
2. Plug the power supply into the printer.
The hole is right next to the power button:
3. Plug the power supply into the wall
4. Don’t turn it on yet!
Connect the Printer to the Computer:
1. Your printer comes with a USB connection cable. This cable has one
flat end and one square end. Plug the square end into the slot on the
back of the printer, next to the power supply:
2. Plug the other end of the cable into your computer – look for a flat hole
that matches your cable, they usually come in pairs.
3. Don’t turn it on yet!
To Next Page
Loading...