Zebra Z4Mplus Quick Start Guide

46 English
Configuration
Configure the Printer
The configuration procedure in the next table contains the
information you need to get your printer up and running,
but it is not comprehensive. Refer to the users guide for
more information.
To enter Configuration Mode, press SETUP/EXIT at the
“PRINTER READY” display.
Remember:
• Press SELECT once to use (+) and (–) to change
the value of the selection.
• Press (+) to scroll to the next selection, increase
the value, answer “yes,” or print a label (when
applicable).
• Press (–) to return to the previous selection,
decrease the value, select the digit you wish to
change, or answer “no.”
• Press SELECT again to use (+) and (–) to scroll
to the desired menu item.
Note • You will need to press (+) more
than once to advance to some of the
displays.
Parameter Selections/Explanation
PRINTER READY You are ready to configure the printer.
DARKNESS 0 to 30 (default setting is 10)
PRINT MODE Tear-Off, Peel-Off, Cutter, Rewind (default setting is Tear-Off)
MEDIA TYPE Non-continuous, continuous (default setting is non-continuous)
SENSOR TYPE Web, mark (default setting is web)
PRINT METHOD Thermal transfer, direct thermal (default setting is thermal transfer)
SAVE CHANGES Permanent, temporary, cancel, load defaults, load last saved (default setting is permanent)
PRINTER READY You have exited Configuration Mode and are ready to print a test label.

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing