51
Setup for Windows OS
Setting Up the Wi-Fi Print Server Option
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
Setting Up the Wi-Fi Print Server Option
This section covers basic configuration of your internal Wi-Fi Print Server option. For more
detailed information, refer to the Wired and Wireless Print Servers User Guide.
You may configure your printer for wireless operation in the following ways. This basic guide
covers only the first option, the Connectivity Wizard.
• Through the Connectivity Wizard, which writes a ZPL script for you. On the last screen of the utility,
you may choose to send the command directly to your printer, or you may choose to save the ZPL script
to a file. The saved ZPL file has several purposes:
• The file can be sent to the printer through any available connection (serial, parallel, USB,
or wired print server).
• The file can be resent to the printer after the network settings have been restored to
factory defaults.
• The file can be sent to multiple printers that will use the same network settings.
• Through ZPL script that you write yourself. Use the ^WX command to set the basic parameters for
security type. You can send the command through any available connection (serial, parallel, USB, or
wired print server). Refer to the ZPL Programming Guide for more information on this option.
• Through Set/Get/Do (SGD) commands that you send to the printer. Begin with
wlan.security to
set the wireless security type. Depending on which security type that you select, other SGD commands
will be necessary to specify other parameters. You can send the commands through any available
connection (serial, parallel, USB, or wired print server). Refer to the ZPL Programming Guide for more
information on this option.
Important • The wireless radio option, which includes Wi-Fi, Bluetooth classic and Bluetooth
low energy, is only available as a factory installed configuration.
To Next Page
Loading...
