Zebra ZD420 - Page 60

52
Setup for Windows OS
Configure Using the Connectivity Wizard
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
Configure Using the Connectivity Wizard
The ZebraNet Bridge Enterprise utility is available through http://www.zebra.com/software.
ZebraNet Bridge Enterprise version 1.2.5 or later is required to configure the printer correctly for
use.
The Connectivity Wizard, which is part of this software, allows you to configure your printer easily
for wireless operation by writing the appropriate ZPL script for you. Use this utility when you are
first installing the wireless print server or after you set the network options back to factory
defaults.
To use the Connectivity Wizard, complete these steps:
1. If it is not already installed, install ZebraNet Bridge Enterprise on your computer.
You can get the program from the user CD that came with your printer, or you can download it at
http://www.zebra.com/software.
2. Launch the ZebraNet Bridge Enterprise program.
If you are prompted for a serial number, you may click Cancel. You will still be able to use the
Connectivity Wizard.
3. From the Menu bar, select Tools > Connectivity Wizard.
The Connectivity Wizard opens.
Note • You can only set up one print server at a time with the Connectivity Wizard. To
configure multiple print servers (wired and wireless), run the program once for each print
server.