Zebra ZQ320 - Features Overview; NFC and Print Touch Feature

P1096702-001 • Introduction • -1-12 •
ZQ320 Series Unit Test & Calibration
Equipment Required
1. A computer with the following minimum conguration:
• Pentium CPU
• 256 MB RAM
• 1 GB Hard Drive
• CD-ROM drive
• SVGA 14 in. monitor and SVGA card
• USB Port
• Windows 7 or Windows 10
• Unit Test Software version 1.0.5.0
2. A bar code scanner using USB communications. (Example: Symbol Model LS1908
series)
3. USB Interface Cable
4. Spare batteries, chargers and test media specic to the printer. Refer to the table in
the “Tools and Supplies” topic in Section 2 of this manual.
Running The Software
CAUTION: DO NOT disconnect the communications cable at any time during the
Unit Test procedure unless prompted to do so by the software!
IMPORTANT: Certain replacement procedures in this manual will require running
the test procedure to verify a repair. It is recommended that you perform the
entire unit test sequence for these procedures to ensure all printer functions are
functional after the replacement.
To Start
• Launch the Unit Test Application.
• Plug the Serial Interface Cable into the printer’s communication port.
• Follow the on-screen instructions.