Zebra ZQ320 - Getting Ready to Print; Battery Installation and Removal

P1096702-001 • ZQ320 Repair Procedures • 2-13 •
Section 2: Replacement Procedures
Make use of the following tools and supplies for maintaining the printer and installing
the repair kits:
Hand Tools
• TORX Drivers T5, T6 & T8
Supplies
• Isopropyl alcohol
• Media, Batteries, and Chargers for ZQ320 printer per table below:
Mobile
Printer
Model #
Test Media Battery Replacement Kit Chargers
ZQ320
Printhead Life (virgin media)
Gear Life (media loop)
10021236: Z-Select 4000D 3.2 mil Receipt
Full Roll Print Quality
10021232: Z-Perform 1000D 2.4 mil Receipt
10021236: Z-Select 4000D 3.2 mil Receipt
10023369: PolyPro 4000D 3.8 mil Receipt
10025301: 8000D 3.2 mil High-Temp Receipt
10023375: Z-Perform 2000D Label
10025305: Z-Perform 1000D 2.4 mil Receipt
10025299: Z-Select 4000D 3.2 mil Receipt
10023371: PolyPro 4000D 3.8 mil Receipt
10025303: 8000D 3.2 mil High-Temp Receipt
NZ222AA#AB2: Media for China customer
10007393: Media for China customer
BTRY-MPM-22MA1-01
BTRY-MPM-22MAC1-01
SAC-MPM-3BCHGUS1-01
SAC-MPM-1BCHGUS1-01
PWR-WUA5V12W0US
CHG-AUTO-USB1
VAM-MPM-VHCH1-01
Handling
The use of an ESD wrist strap at a properly grounded workstation is required when
handling printed circuit boards or other sensitive electronic components. The ESD
strap prevents any electrostatic damage to occur while assembling these components.
The use of the ESD strap will be noted in the applicable instructions.
This symbol indicates that the operator must wear a properly grounded ESD strap
to perform the repair procedure.
Storage
Replacement kits which are sensitive to ESD damage are supplied in static resistant
packaging. Always keep these parts in their original packaging until they are to be
installed.
Tools and Supplies