Zebra ZQ320 - 3-Slot Battery Charger; Charging Temperature Guidelines

P1096702-001 • ZQ320 Repair Procedures • 2-19 •
Removing the Latch Assembly
1. Use a 1.5 mm Hex driver or T6
TORX driver to remove the set screw
on the Side Latch Gear (where shown).
2. Remove the Side Latch gear from
the end of the Cover Latch Shaft.
3. Slide the Cover Latch Shaft from the
printer frame (and through the Torsion
Spring) by the Side Latch Sensor.