P1096702-001 • ZQ320 Repair Procedures • 2-21 •
5. Install the Side Gear Latch on the
opposite side of the shaft. Use a 1.5
mm Hex driver (4.7 +/- 1 in. lb.) to
tighten the set screw.
Installing the Printer Gears
1. Place the Idler Gear on its post on
the Gear Plate.
2. Place the two (2) Compound Gears
on the two posts on the Gear Plate.
3. Place the Gear Plate Assembly onto
the Printer Frame (as shown).
3. Use the T-8 driver to secure the
Gear Plate Assembly onto the Printer
Frame with the two (2) screws.
Ensure that the ground strap is
secured to the outside of the Gear
Plate with the top screw.
To Next Page
Loading...