Zebra ZQ510 - Troubleshooting Topics

45
ZQ500 Series User Guide
DC
Icon Status Indication
Blinking Data processing in progress
Steady No data being received
Blinking Out of media
Steady Media present
Blinking Media cover open
4 Bars >80% charged
3 Bars 60%-80% charged
2 Bars 40%-60% charged
1 Bar 20%-40% charged
0 Bars Low Battery
On Battery Eliminator present
(Replaces Battery icons)
On
(Media Out icon Off)
Printer in Segmentation Mode
On
(Media Out icon Off)
Printer in Draft Mode
Troubleshooting Topics
1. No power:
• Check that battery is installed properly.
• Recharge or replace battery as necessary.
• If using battery eliminator, ensure that it is connected properly
to power source
Always dispose of batteries properly. Refer to Appendix F for more
information on proper battery disposal.
2. Media does not feed:
• Be sure media cover is closed and latched.
• Check spindle holding media for any binding.
• Ensure label sensor is not blocked.
3. Poor or faded print:
• Clean print head.
• Check quality of media.