© 2016 ZIH Corp and/or its affiliates. All product names and numbers are
Zebra trademarks, and Zebra and the Zebra logo are registered trademark
s of
ZIH Corp. All rights reserved.
P1089072-001
10/10/16
ZT410 Printer with Silverline
Media Printing Solution
Setup Instructions
Lower the Media Sensor
and Ribbon Strip Plate (if necessary)
1. Loosen the 3 mm Allen screw located directly underneath the adjustable transmissive
media sensor.
2. With your fingers, grab the lower half of the transmissive media sensor housing (near the
mainframe) and pull it downward as far as it will go, and then re-tighten the screw. This
sets the media sensor housing to accommodate the thickest media.
Note • Each ZT410 printer with the Silverline media printing solution should leave the
manufacturing plant with both the media sensor and the ribbon strip plate in the lowest
position. If this is not the case, complete the instructions in this section.