Adjust and Configure the Printer
2
P1089072-001 10/10/16
Adjust and Configure the Printer
1. Loosen the two fasteners on the ribbon strip plate.
2. Lower the ribbon strip plate as far down as it will travel, and then re-tighten the screws.
3. Using the printhead pressure adjustment dials, set each barrel to the correct position for
your media, as identified in Table 1.
1
Inside dial
2
Outside dial
Table 1 • Toggle Pressure Settings
Tag Inside Dial Setting Outside Dial Setting
Micro 3 2
Classic 3 3
Slim 3 3
Blade 3 2
To Next Page
Loading...