Zebra ZT410 - Compliance Information

Load Media and Calibrate the Printer
4
P1089072-001 10/10/16
Load Media and Calibrate the Printer
1. Open the printhead, and then load the Silverline media and Zebra 5095 resin-based ribbon.
For specific loading instructions, refer to the ZT410 RFID Printer User Guide for the
Silverline Media Solution.
2. Position the adjustable transmissive media sensor, so that the visible red LED shines on
the gap between the labels.
(View: printhead open, looking down the throat of the printer.)
3. Close the printhead, and then press the PAUSE button to enable printing.
The printer calibrates. If the calibration fails or if the printer displays a
media error, perform a manual media and ribbon calibration. (For
instructions, see the calibration video or the printer’s User Guide at
http://www.zebra.com/silverline.)
4. On the printer’s control panel, press LEFT SELECT to go to the Home menu.
5. Press the RIGHT ARROW until you reach the RFID menu.
6. Press OK to enter the RFID menu.
7. Press the LEFT ARROW or RIGHT ARROW until you reach RFID CALIBRATE.