5
Load Media and Calibrate the Printer
10/10/16 P1089072-001
8. Press the RIGHT SELECT button to begin the RFID calibration process.
The printer determines the optimal read/write power and antenna location to use for your
tags. For additional information about these settings, find the transponder information for
your printer at http://www.zebra.com/transponders.
9. On the printer’s control panel, press LEFT SELECT to go to the Home menu.
10. Press the RIGHT ARROW until you reach the TOOLS menu.
11. Press OK to enter the TOOLS menu.
12. Use the arrow buttons to scroll to and adjust the following parameters in the Settings
menu. For this application, Zebra recommends that you use the following settings:
• POWER UP ACTION = FEED
• HEAD CLOSE ACTION = FEED
Your printer is now ready to print.
Important • These settings cause a tag to be fed each time the printer is powered up or each
time the printhead is closed.
To Next Page
Loading...