6: Cleaning
Cleaning the Laminator
P1036101-001 Zebra ZXP Series 7 Card Printer User’s Manual 123
Clean the Laminator Card Path
Step 1. From the Clean Printer Menu, select CLEAN LAM CARD PATH to run the Laminator
Cleaning Routine; and follow the OCP instructions.
Step 2. Wait until the oven temperature falls below 60
o
C.
Step 3. If you have laminate installed, open the laminator covers, remove the laminate (top
and bottom cassettes), and close the covers.
Step 4. Open the print cover (to raise the printhead), then press Next.
Step 5. Insert the Laminator Cleaning Card into the Manual Feed Slot, then press Clean.
Step 6. Wait while the cleaning process completes.
Step 7. The card will be ejected into the output hopper.
Step 8. The OCP will return to the Clean Printer Menu.
Step 9. If you want to clean the Laminator Media Rollers at this time, see Clean the
Laminator Media Rollers on page 124; otherwise, go to Step 10.
Step 10. Open the laminator covers, install the laminate (top and bottom spools), and close
the covers.
Step 11. Close the print cover.
To Next Page
Loading...
