22
Configuring Wireless through the Printer Web Page
This requires that the printer be connected to a computer through wired Ethernet. Set the
DHCP mode, IP Address Subnet Mask and Default Gateway as needed for the wired interface. If
DHCP is enabled, use the OCP INFO soft-key to determine the IP Address for the wired
Ethernet. Open a browser window on a computer connected to the same network as the
printer and enter the printer IP address, like:
http://10.14.4.69
The printer web page should then display:
Click on the “Wireless Parameters” entry from the list of the left of the web page and enter
User name (default is: admin) and Password (default is: 1234). The web page now changes to
one specific to wireless setup:
To Next Page
Loading...
