Zebra ZXP Series 8 - Page 125

5: ZXP Series Toolbox
Cleaning
P1045430-002 Zebra ZXP Series 8 Card Printer User’s Manual 121
• Laminator Rollers (see Cleaning: Laminator Media Feed Rollers on page 136).
1. Open the laminator cover, remove both laminates, prepare an alcohol swab, and click
the Next button.
2. Click the Top button, and clean the top feed roller (with the alcohol swab) until it
stops turning.
3. Click the Bottom button, and clean the bottom feed roller (with the alcohol swab)
until it stops turning.
4. When completed, install both laminates; and click the Close button to conclude the
laminator rollers cleaning process.
• Laminator Oven (see Cleaning: Heater Assembly Rollers on page 138).
1. Wait until the transfer temperature falls below 60
o
C.
2. Open the laminator cover, remove the oven assembly, and click the Next button.
3. Clean both rollers with the adhesive card, and click the Next button when completed.
4. Install the oven assembly, and click the Close button to conclude laminator oven
cleaning process.