P1045430-002 Zebra ZXP Series 8 Card Printer User’s Manual 131
6
Cleaning
Cleaning the Printer
Clean your Printer using the Cleaning Cards provided. The regular use of these cards will
clean and maintain important parts of your printer that cannot be reached, including the
Printhead, Transport Rollers, and optional Magnetic Encoder Station.
Printer usage (total number of cards printed and total number of cards laminated) can be found
on the printer’s Properties, Device Information tab. To access the Device Information tab,
select Start > Devices and Printers. Then right-click on the Zebra ZXP Series 8 Card Printer
listing, and select Properties > Device Information.
When to Clean
• X-Roller and Y-Roller cleaning should occur every 5,000 cards.
• Heated Roller cleaning should occur every 20,000 cards. Note that a Heated Roller
Cleaning Card is not supplied with the printer; order Zebra Cleaning Card Kit
P/N 105999-801.
Caution • PROTECT YOUR FACTORY WARRANTY!
The recommended maintenance procedures must be performed to maintain the factory
warranty. Other than the recommended cleaning procedures described in this manual,
allow only Zebra authorized technicians to service the Printer.
NEVER loosen, tighten, adjust, or bend, etc., a part or cable inside the printer.
NEVER use a high-pressure air compressor to remove particles from the printer.
To Next Page
Loading...
