2: Installation and Setup
Loading the Laminate
P1045430-002 Zebra ZXP Series 8 Card Printer User’s Manual 29
Laminating Contact Smart Cards
The laminate for the top surface of a contact smart card has a repeating pattern of an index hole
and a rectangular cutout to expose the card’s electrical contacts.
Step 1. Remove the Upper Laminate Cassette; see Page 22.
Step 2. Open the cassette, and remove the laminate if present.
Step 3. Load the smart card laminate into the cassette; see Page 24.
Step 4. Cut the laminate, splitting the index hole as shown.
electrical contacts
index hole
rectangular cutout
Cut the laminate, splitting the
index hole
To Next Page
Loading...
