Page 11 | ZvSync-NA User’s Manual www.zeevee.com
To program a key the following sequence shall be executed:
'
• Step1: Press and hold the “SET” button for three seconds
! The RED LED lights immediately when the button is pressed
! After 3 seconds the LED changes to a very bright state
• Step 2: Press the key you wish to program (P1-P5)
! The RED LED changes to a slow flash (1/second)
• Step 3: Press the key on the remote that you are copying
! The RED LED performs three quick flashes to acknowledge
! RED LED turns on solid again.
! Repeat steps 2 and 3, or simply wait for light to extinguish
• Step 4: Test Programmed key on television or device to be controlled
o If command is not executing properly, repeat steps 1-3
To Next Page
Loading...