Zelmer 13z012 User Manual (English)

Questions and Answers:

O
oconnellangelaSep 9, 2025
What to do if Zelmer Coffee Maker coffee does not run through?
- G
  Glenda JohnsonSep 9, 2025
  If the coffee does not run through your Zelmer Coffee Maker, first, fill up the water tank with water and ensure it is properly installed by pressing it down. Make sure the regulator knob is in the correct position. If the filter on the brew head is blocked, consider descaling. If the coffee filter is blocked, empty it and rinse it under running water. Wipe the brew head with a cloth and clear the holes of the filter using the grey pin, then refill with coffee, tamping less firmly.
T
Travis CastilloAug 23, 2025
Why doesn't my Zelmer 13z012 espresso have foam?
- M
  Mary TerrellAug 23, 2025
  If your Zelmer Coffee Maker's espresso lacks characteristic foam, ensure you are using fresh coffee stored in a tight container after opening. Tamp the coffee more firmly and use properly ground coffee, or consider changing the coffee brand. Also, ensure you are using enough coffee in the filter.
M
Mariah NelsonAug 25, 2025
Why does no coffee run through my Zelmer 13z012 Coffee Maker?
- M
  Melinda HudsonAug 25, 2025
  If your Zelmer Coffee Maker isn't dispensing coffee, first, ensure the water tank is filled and properly installed. Check that the regulator knob is in the correct position. If the brew head filter is blocked, see the descaling instructions. If the coffee filter is blocked, empty it, rinse under running water, wipe the brew head, clear the filter holes with the grey pin, and refill with coffee, tamping less firmly.
J
John LambertAug 26, 2025
What to do if the holder loosens during brewing in my Zelmer 13z012?
- T
  Tiffany OliverAug 26, 2025
  If the holder loosens during brewing with your Zelmer Coffee Maker, try tamping the ground coffee less firmly or switching to a coarser coffee. Ensure the coffee holder is correctly placed and tightly secured in the brew head. Clean the filter rim and remove any coffee from the brew head. Wipe a dirty brew head with a damp cloth. If the brew head or its rubber seal is damaged, contact an authorized service center.
T
Timothy FrancoAug 27, 2025
Why does coffee filter out in drops from my Zelmer 13z012 Coffee Maker?
- M
  Melissa ButlerAug 27, 2025
  If your Zelmer Coffee Maker is dispensing coffee in drops, it might be because the coffee is ground too finely or tamped too firmly; if using very finely ground coffee, avoid tamping it too firmly. Also, the appliance may be blocked with scale build-up, so refer to the descaling instructions.
B
Bob CarterAug 29, 2025
Why does my Zelmer 13z012 espresso have a burnt taste?
- M
  Megan AllenAug 29, 2025
  If your Zelmer Coffee Maker's espresso tastes burnt, the coffee you're using might be unsuitable; try other brands. Also, if you recently descaled the appliance, ensure you rinse it thoroughly with a full tank of water before brewing more coffee.
A
Anthony TylerSep 14, 2025
Why am I not getting enough frothed milk from my Zelmer Coffee Maker?
- J
  Jeanette Costa DDSSep 14, 2025
  If you are not getting enough frothed milk from your Zelmer Coffee Maker, check if the milk is fresh and properly cooled before use. For best results, use the stainless steel jug provided, cooling it down or rinsing with cold water if possible. If the steam wand is blocked, see the Maintenance and cleaning section. Ensure the milk has not been boiled; if it has, try again using fresh, cooled milk.
N
npaulSep 12, 2025
Why does the holder loosen during brewing on my Zelmer Coffee Maker?
- J
  josephmyersSep 12, 2025
  If the holder loosens during brewing with your Zelmer Coffee Maker, tamp the ground coffee less firmly and change to a coarser coffee grind. Ensure the coffee holder is placed correctly and tightened securely in the brew head. Clean the rim of the filter and any coffee from the brew head. Wipe the brew head with a damp cloth. If the brew head or rubber seal is damaged, contact an authorised service center.
A
Anthony EatonSep 7, 2025
How to fix coffee running out around the edge of the filter holder on Zelmer Coffee Maker?
- J
  Jessica MccarthySep 8, 2025
  If the coffee runs out around the edge of the filter holder of your Zelmer Coffee Maker, ensure the holder is properly inserted in the brew head unit and tightened securely. Also, clean the rim of the filter and wipe any coffee grounds from the brew head. If the brew head is dirty, wipe it with a damp cloth. If the brew head or the rubber seal is damaged, contact an authorised service center.
B
berryjamesSep 4, 2025
Why does my Zelmer Coffee Maker not work?
- W
  Wesley HollowaySep 5, 2025
  If your Zelmer Coffee Maker isn't working, the filter in the brew head may be blocked. Remove the filter head and clean the brew head unit, referring to the maintenance and cleaning instructions. Also, the appliance might be blocked with scale build-up, so refer to the descaling instructions.