Zenith TRANS-OCEANIC H500 - Operating Instructions for the Zenith Radio; Preparing the Receiver for Operation

degree permitting
great
ease of
tuning. A calibrated
second
scale has
been incorporated in the top edge of the
dial face. It
permits
short-
wave
stations
to
be
accurately logged and easily
relocated.
All parts
are
fully
treated
against
moisture,
temperature,
and
other climatic
conditions. Variations
in
the
performance
of
the
receiver
because of
seasonal or
geographic changes
are
held to a
minimum,
and
the receiver
will
operate
at
its maximum
efficiency
throughout
the world Power
consumption
on
the electric light line
is 10
watts.
When
the receiver is to be used
in
areas
outside of
continental
U.
S. A.
where 110
volts
AC/DC is
usually
not
available,
ballast
adaptor
No.
S-15715
must be used.
This
ballast adaptor
reduces 220 volts AC
or
220
volts DC to
110 volts
AC or
110 volts
DC
necessary for
proper
operation of the
receiver.
READ CAREFULLY
—
KNOW
YOUR
ZENITH
PLUG
SPARE
T1J8E
HOLDER
W&TftUCTJON
BOOK
t"XT£lS5iON
CORD
POWER
PLUS
power
com?
DRY
&ATTLRY
PACK
BATTERY
PACK
SODKfiT
SUCTION
CUPS
Figure
I. —
Rear
View,
Back
Cover
Open.
1. PREPARING
THE
RECEIVER
FOR
OPERATION
A.
OPEN
REAR
DOOR
OF
CASE by simply
pulling on finger grip
provided.
B.
Place
the battery
pack
into
the compartment
provided below the