Zenith TRANS-OCEANIC H500 - 220-240 Volt Operation

220-240
Volts DC or
AC
—
25
to
60
cycle
operation.
E.
If the
receiver
is
to be
used in
locations
where a
current supply of
220-240
Volts
AC
or DC
is
available,
ballast
adaptor S
15715
should
be
used.
This
ballast adaptor
assembly
can
be
obtained from
your local
Zenith
distributor
and need
only be
plugged
into the
ballast
tube
socket.
(See
Figure
4.)
Figure
4.
—
Ballast
Adaptor
Inserted in
Socket.
1.
Loosen
the
screw
holding
the
switch
positioning
plate.
2.
Move
the
switch
on
the
ballast tube to
either
110
volts
AC-DC,
220
volts DC or
220
volts
AC
position
to
conform
to the
type
current on which the
set is
to
be
operated.
(See
Figure
5.)
Figure
5.
—
Ballast
Tube Switch Positions.