Zenith ZRS4584W - Installation Transportation Instructions

EN
9
3 Installation
Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the frontof the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. Empty any water in the drain
tray before moving see section
“Defrosting” and “Cleaning & Care” for
further information
Important: Make sure the plastic
evaporating pan at the back of the
product collects water properly.
Important:Care must be taken whle
cleanng / carryng the applance to
avod touchng the bottom of the
condenser metal wres at the back of
theapplance as you mght njure your
fngers and hands.
Important:Ths applance s not
desgned for stackng wth any
otherapplance.When postonng
your applance, take care not to
damage your floorng, ppes,wall
coverngs etc. Do not move the
applance by pullng by the door or
handle.Do not attempt to st or stand
on top of your applance as t s not
desgned forsuch use. You could njure
yourself or damage the applance.
Important:Make sure that mans
cable s not caught under the
applancedurng and after carryng
/ movng the applance, to avod
the mans cablebecomng cut or
damaged.”Do not allow chldren to
play wth the applance or tamper
wth the controls.
Installation Instructions
1. If possible avoid placing the
appliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods. If
installed next to a source of heat or
refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
2. No gap is required at sides
and top. See item 3 below to ensure
a gap is obtained at the rear of the
appliance. If a gap is available on side
and top, retain it if possible as it would
improve the air circulation around the
appliance.
3. Fit the two plastic wall spacers
supplied with the appliance rotating
1/4 turn to the condenser at the back
of the refrigerator (see diagram).
4. The appliance should be
located on a smooth surface. The two
front feet can be adjusted as required.