Zenoah G230RC - User Manual

Questions and Answers

Y
Yvonne ClarkJul 31, 2025
How to fix no spark in Zenoah G230RC spark plug?
- R
  Randy GriffinJul 31, 2025
  If your Zenoah Engine isn't sparking, the issue could stem from several causes: * Wet spark plug electrodes: Make sure they are dry. * Carbon deposits on the electrodes: Clean them. * Insulation failure due to insulator damage: Replace the insulator. * Incorrect spark gap: Adjust it to 0.6~0.7mm. * Burned-out electrodes: Replace them. * Internal ignition coil failure: Replace the coil. * Damaged cable sheath or disconnected cable: Replace or repair the cable. * Switch is OFF: Turn the switch ON. * Switch failure: Replace the switch. * Primary wiring earthed: Repair the wiring.
D
Daniel BrownAug 11, 2025
Why is my Zenoah G230RC overheating?
- C
  Carmen LeeAug 11, 2025
  If your Zenoah Engine is overheating, it could be due to: * Fuel mixture being too lean: Adjust the carburetor. * Cylinder fins clogged with dust: Clean the fins. * Poor fuel quality: Replace with proper fuel. * Carbon deposits in the combustion chamber: Clean the chamber. * Spark plug electrode red hot: Thoroughly clean and adjust the spark gap to [0.6~0.7(0.023~0.028in)].
V
victoriaschultzAug 20, 2025
What to do if Zenoah Engine lacks power?
- T
  Thomas GoodmanAug 20, 2025
  If your Zenoah Engine lacks power or runs unstable, check the following: * Air entering from fuel pipe joints: Secure the connection. * Air entering from intake tube or carburetor joint: Change the gasket or tighten the screws. * Water in the fuel: Replace with good fuel. * Piston starting to seize: Replace the piston (and cylinder). * Muffler choked with carbon: Clean the muffler.

Zenoah G230RC Specifications

General

Fuel Type	Gasoline
Fuel Mixture	25:1 (gasoline:oil)
Starter	Recoil Starter
Engine Type	2-stroke
Displacement	22.5 cc
Bore	32 mm
Stroke	28 mm
Ignition System	Electronic
Carburetor	Diaphragm type