Zenoah G230RC - Engine Starting; Operation

3. Engine Starting
4. Operation
• Push the primer pump several times until
overflown fuel flows out. (Fig.1)
• Close the choke lever(Fig.2), and move the
throttle lever 1/4~1/3 open position.
• Pull the starter(knob) quickly until first firing
noise. (Fig.3)
• Open the choke(Fig.2), throttle idle~1/4 open
• Pull the starter quickly
• Operate engine for a few minutes for the
warming up.
• In case of engine warm condition, choking may
not be necessary.
• Over choking may cause starting difficulty due
to wet spark plug.
In this case change spark plug or dry it, and
remove fuel rest in the cylinder by pulling
starter.
IMPORTANT
• This engine is already tuned up to get high
power and high speed, and needs correct
maintenance to keep such high performance.
• The details for operation may be described in
the separate owners manual to be issued by car
manufacturer.
• Be sure to have the engine cool down for 30
seconds at idle speed after full throttle running.
Fig.1
Choke
Lever
Open
Close
Throttle Lever
Fig.2
Fig.3
4