17
SERVICE GUIDE
3) ASSEMBLING ROTOR
Insert the gauge(3330-97310) in between the rotor
magnet metal and the coil.Tighten screws while pressing
the coil against the rotor.
Air Gap 0.3 ~ 0.4mm
4) REMOVING PISTON PIN
1. Remove snap rings from both sides of the piston pin.
2. Engage the rod assy(848W10000) to the piston pin
and gently tap with a plastic hammer to push out the
pin while holding piston firmly.
Hard hammering may damage the big end of the
connecting rod.
To Next Page
Loading...
