Fig.2
Fig.3
• Push the primer pump several times until overflown fuel
flows out. (Fig.1)
• Close the choke lever(Fig.2), and move the throttle
lever 1/4~1/3 open position.
• Pull the starter(knob) quickly until first firing noise.
(Fig.3)
• Open the choke(Fig.2), throttle idle~1/4 open
• Pull the starter quickly
• Operate engine for a few minutes for the warming up.
• In case of engine warm condition, choking may not be
necessary.
• Over choking may cause starting difficulty due to wet
spark plug.
In this case change spark plug or dry it, and remove
fuel rest in the cylinder by pulling starter.
To Next Page
Loading...
