How to fix a ZEP Dyna-Clean pump that runs but does not pump fluid?
If your ZEP Washer pump runs but doesn't pump fluid, it could be due to: * A clogged pump filter screen. Clear any debris from around the pump. * A clogged flexible plastic hose. Clear any debris from the hose. * A clogged pump rubber discharge hose. Clear debris from the hose or replace the hose.
Why ZEP Dyna-Clean pump does not run?
If the pump on your ZEP Washer isn't running, there are several potential causes: * The machine might not be plugged into the outlet. If this is the case, plug the machine into the outlet. * The pump might not be plugged into the electrical box. If this is the case, plug the pump into the electrical box. * The circuit breaker might be tripped. If this is the case, check the breaker and correct it. If problems persist, contact Graymills. * The pump motor might be burned out. If this is the case, replace the pump. * There may be a faulty switch. If this is the case, replace the switch.
What to do if the light does not turn on in my ZEP Washer?
If the light on your ZEP Washer isn't turning on, here are a few things you can check: * Ensure the machine is plugged into the outlet. If not, plug it in. * Make sure the light is properly plugged into the electrical box. Plug it in if it isn't. * Check the circuit breaker and correct if tripped. If problems persist, contact Graymills. * The bulb may be burned out, so replace it. * A faulty switch on the lamp could be the issue, so replace the lamp.
What to do if ZEP Dyna-Clean pump runs but is noisy?
If your ZEP Washer pump runs but is noisy (note that some noise is normal), it could be due to cavitation caused by a low liquid level. To resolve this, raise the liquid level to the correct level.
Why ZEP Dyna-Clean Washer pump runs but does not pump fluid (external filter units)?
If your ZEP Washer pump runs but does not pump fluid and you are using external filter units, the canister filter may be clogged. Replace the external filter to resolve this issue.
Inspect equipment for shipping damage upon receipt and report any issues.
Lists key features of the Zep Dyna-Clean parts washer.
Explains safety symbols (DANGER, WARNING, CAUTION) and alert meanings.
Covers temperature limits, ventilation, flammable vapors, and fluid flash points.
Details electrical connection safety, grounding requirements, and hazards.
Addresses fusible link, low liquid levels, proper fluid use, and fire prevention.
Covers PPE, floor conditions, load capacity, unit stability, and reporting issues.
Guidance on selecting a suitable location and preparing for installation.
Step-by-step instructions for assembling and connecting the parts washer.
Explains the operation of the gas spring and fusible link for the safety cover.
Instructions for regularly cleaning the unit and its components for optimal performance.
Steps for safely changing cleaning fluid and disposing of used fluid.
To Next Page
General