ZEP Dyna-Clean - SAFETY WARNINGS AND CAUTIONS; Safety Symbol and Alert Definitions; General Operating and Environmental Safety; Electrical Safety and Grounding

786-93885 3 of 14 6/6/22
SAFETY WARNINGS/CAUTIONS
Read all of the SAFETY INSTRUCTIONS on the machine and those in the manual BEFORE
installing or using this equipment. Keep this manual handy for reference/training.
You will find various types of safety information on the following pages and on the labels attached to
Zeps equipment. The following Safety Statements explain their meaning.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey
all safety messages that follow this symbol to avoid personal injury or death.
DANGER indicates a hazardous situation which, if not avoided, will result in death
or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous situation which,
if not avoided, could result in minor or moderate injury.
CAUTION, without the safety alert symbol, is used to address practices not related
to personal injury.
Read and understand the user manual before operating this unit.
Do not operate above 100°F (38°C) maximum ambient temperature, near open flames, sparks, or
smoking materials. Keep cover closed when unattended.
To provide continued protection against risk of electrical shock, fire, and explosion, connect to
properly grounded supply or outlets only.
Risk of explosion. This equipment has internal arcing and sparking parts, which shall not be
exposed to flammable vapors. This equipment shall not be located in a recessed floor are or below
grade.
Only cleaning fluids with a flash point at or above 104°F (40°C) shall be used. Refer to user
manual for a list of solvents which have been evaluated for use.
For your protection and to maintain the performance of the cleaning process, do not contaminate
cleaning solution with fluids below 104°F (40°C) flash point. Do not dump gasoline, alcohol, used
oil, paint, lubricants, flammable liquids, chlorinated solvents, or other chemicals into this parts
cleaner. Even small amounts will create a hazardous condition.
Ensure fusible link and closing device are in proper working order. Fusible link melts at
165°F(74°C) causing lid to close. When open the lid must lean forward so it will close automatically
when link melts. Do NOT tamper with or remove the fusible safety link. If the safety link breaks or
is lost, do NOT use the unit. Replace the safety link immediately.
Hazardous voltage present. Disconnect power before repairing or cleaning. Unit must be properly
grounded to prevent electric shock, fire, and explosion hazard. Connect only to three prong outlets.
Should cord become cracked, frayed, or damaged in any way, it should be repaired immediately
by a qualified electrician. Never use an extension cord. Since operator safety at all times is a
priority, we strongly recommend that, whether or not required by local code, this equipment be
connected only into a power supply equipped with a “Ground Fault Interrupter” (GFI). All electrical
connections should conform to national/local codes and be made by qualified personnel.
Do not leave objects in the tank or let hose attachments exit the tank which prevent lid from closing
completely in the event of fire.