To Next PageTo Next PageWhat to do if safety grille is vibrating on Zephyr Hurricane AK2500CS?
If the safety grille is vibrating on your Zephyr Ventilation Hood, it's likely that the safety grille is loose. Tighten the safety grille screw to resolve this issue.
Why are the lights not working on my Zephyr Ventilation Hood?
If the blower is working, but the lights are not on your Zephyr Ventilation Hood, it could be due to a few reasons. Check if the LED light connector is disconnected and connect it. If the connector is fine, the LED light might be defective and need to be replaced. Another possibility is that the switch board or control board is defective, requiring you to change it.
General| Color | stainless steel |
|---|---|
| Hood Type | under cabinet |
| Venting Type | ducted, external |
| Temperature Sensor | no |
| Number of Fan Speeds | 3 |
| CFM | 695 cubic feet per minute |
| Sones | 5.5 sones |
| Control Type | button |
| Delay Start | yes |
| Interior Light | yes |
| Remote Control | no |
| Voltage | 120 volts |
Weight and Dimensions| Depth | 20 1/8 inches |
|---|---|
| Height | 7 inches |
| Width | 29 3/4 inches |
| Net Weight | 30 pounds |
Covers fire, electrical, ducting, and health hazards.
Recommended dimensions for hood installation above the range.
Detailed dimensions and specifications for the AK21 model.
Detailed dimensions and specifications for the AK25 model.
Detailed dimensions and specifications for the AK65 model.
Explanation of controls for the AK21 model with capacitive touch.
Explanation of controls for the AK25 model with electronic touch.
