20
Titan Use, Care, and Installation Guide
TITAN
WALL
PRO
Installation Instructions
Dual Blower Horizontal Ducting Conversion
5. Knock out plate A for dual blower
horizontal ducting.
A
6. Position dual blower inside hood
body. Attach by (4) screws
previously removed from step 2.
Follow steps 1 to 4 on page 18, then continue PBD-1300B dual blower horizontal ducting conversion by
following the steps below.
7. From inside hood body, position
top cover plate to top of hood
body. From outside hood body,
attach top cover plate to top of
hood body using (4) 3/16 x 3/8
screws.
8. Attach 10 inch round blower
collar to back of hood using (4)
M4x8 screws. Refer back to last
step on page 19 for connecting
the wires.
To Next Page
Loading...
