56
30. Dry-fit the four sides as before, with the front edges down on the table. Apply some wood glue to
one end of the TOP. Smooth the glue with a screw until it uniformly coats the end.
168
168
31. Fit two wood screws into the appropriate two holes of the mating SIDE piece.
169
Guide the tips
into the little pilot holes in the TOP piece. Set a clamp across the box as shown, barely snug.
170
Carefully line up the joint as before.
171
169 170
171
32. Add the second clamp right across the joint and apply moderate pressure to hold the joint
securely for screwing.
172
172
To Next Page
Loading...