55
27. Disassemble the four pieces. With the 9/64 bit, re-drill the eight small holes you drilled in the
sides, and countersink them. You will get cleaner holes if you can drill straight through and into a
piece of plywood or a board.
165
Also, at this time, use the 9/64 bit to drill the 4 chassis
mounting screw holes in the front of the cabinet. With a 5/64 bit drill the 4 badge mounting
holes in the front as well.
165
28. Change to a 3/16” bit and drill the two holes for the handle in the cabinet Top.
166
166
29. Inspect the inside faces of the wood pieces for splinters or “blowout”: bits of wood standing
above the surrounding surface. Clean these off with a bit of 120-grit sandpaper.
167
167
To Next Page
Loading...