54
24. When you are satisfied with the alignment of the corner, add the second clamp as shown and
tighten both clamps moderately to securely hold that joint in place for drilling.
161
NOTE: Take your time with this step. The overall neatness of your cabinet depends on getting
this step right.
161
25. Fit your drill with the 5/64” bit, sticking out about 1-1/8”. At the corner you lined up, drill two
holes at the nail marks, through the side, and into the mated wood piece.
162
162
26. Continue to the other three corners, loosening the clamps and lining up the corners one by one.
Drill a total of 8 holes.
163,164
163 164
To Next Page
Loading...