Troubleshooting
6.3
NUMBER OF RED FLASHES CAUSE SOLUTION
1
Motor Stop Switch Disabled or Kickstand
Switch Dis
abled
Motor stop switch is in the OFF position. Press the
mot
or stop switch ON button. Kickstand is down.
Raise kickstand.
2 Self-Test Failed Contact Zero or your dealer.
3 Charger Connected Unplug charger.
4 High Throttle Disable
Throttle is ON or throttle/connection is bad. Verify
t
hrottle action and/or check connection.
5 Precharge Fail
Could not pre-charge motor controller. Contact your
dea
ler.
6 Low Power Pack Disable Charge Power Pack Before Riding.
7 Contactor Error Contact Zero or your dealer.
8 Controller Area Network (CAN) Error Contact Zero or your dealer.
9
Battery Management System (BMS)
Throttle Disable
Contact Zero or your dealer.
10 Battery Temperature Sensor Fault
Motorcycle will run, but needs service. Contact your
dea
ler.
11 Welded Contactor Contact Zero or your dealer.
Zero Owner's Manual (S and DS).book Page 3 Tuesday, January 20, 2015 2:37 PM
To Next Page
Loading...
