Zero Motorcycles ZERO SR - General Troubleshooting

Troubleshooting
6.8
General Troubleshooting
SYMPTOM POTENTIAL CAUSE POTENTIAL SOLUTION
Motorcycle does not turn on Power Pack not charged. Key not properly engaged.
M
otor stop switch turned OFF. Fault code set.
Charge Power Pack. Recheck key in ignition, turn OFF/ON
again. Press the motor stop Switch ON button. See Charge
Fault Code chart on page
6.10 or see Understanding BMS
Flash Code Patterns starting on page
6.10.
Charger not working A/C power missing. Fault code set Check A/C outlet for power, A/C source check fuse/voltage.
Se
e Charge Fault Code chart on page
6.11 or see
Understanding BMS Flash Code Patterns on page
6.11.
Handlebars wobbly (shimmy) Incorrect tire pressure Inflate to correct tire pressure. See page
5.13.
Deformed front tire Replace/balance front tire with the same tire supplied from the
fa
ctory.
Bald tire (excess wear) Replace/balance tire with the same tire supplied from the
fa
ctory.
Loose headset bearings Inspect the headset for wear or dama
ge, replace any worn or
damaged parts. Tighten the headset pre-load.
Zero Owner's Manual (S and DS).book Page 8 Tuesday, January 20, 2015 2:37 PM