EasyManua.ls Logo

Zero Motorcycles ZERO SR - Power Pack Charging and Maintenance

Zero Motorcycles ZERO SR
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Operation
4.5
OFF Position
This position is used to turn the motorcycle OFF, disabling
the electrical system.
ON Position
This position is used for operating the motorcycle.
In this
position the following sequence occurs:
Lights turn ON
Dash display turns ON
Power Pack
The battery is located within the power pack and requires
no special break in period.
The Zero S/SR/DS power pack leverages proven battery
cell
chemistry, configuration, and enhanced reliability. Not
only does the Z-Force® technology enable you to go
longer distances (range may vary depending on riding type
and conditions), it is also designed to last the life of the
motorcycle. The integrated onboard charger minimizes
charge time and can work in parallel with Zero’s quick
charge accessories to cut charge times by as much as
70%.
The charging time will remain the same if the onboard
charge
r is connected to a 120 V AC or a 240 V AC supply.
The normal recharging time of the power pack to a 100%
charge is usually less than 7 hours for the ZF9.4 and 8.1
hours for the ZF12.5 in mild ambient temperatures. Out of
the normal temperature range, charging and run-time
times will vary. The power pack should not be used outside
of the range of 23°F to 140°F (-5°C to 60°C); the Battery
Management System (BMS) turns off the power controller
outside of this range.
Note: The Battery will not charge if below 0°C or 32°F.
It is required that you leave the motorcycl
e on the charger
if you expect it to sit in storage or unused for over 30 days.
Zero Owner's Manual (S and DS).book Page 5 Tuesday, January 20, 2015 2:37 PM

Table of Contents

Related product manuals