General Maintenance
5.19
Turn Signal Light Bulb Replacement
1. Remove the turn signal lens screw (A) and remove the
lens.
2. Push in on the bulb, turn the bulb counterclockwise,
and
then pull the bulb out.
3. Insert the new bulb into the socket, push in and turn
clockwise until
it stops.
4. Install the lens and screw; tighten the screw. Do not
over-tigh
ten the screw.
Brake/Tail LED Replacement
The brake/tail LED (A) is not serviceable. Please contact
your Zero Motorcycle dealer for replacement.
Zero Owner's Manual (S and DS).book Page 19 Tuesday, January 20, 2015 2:37 PM
To Next Page
Loading...
