22
6.13 DVR MODE
When the DVR MODE is activated, the ZX-40 will continue to record
until the unit has run out of power. The ZX-40 default setting is OFF. To
change this setting, follow the below steps:
1. If you are currently in VIDEO MODE and RECORDING, you
will need to press the SHOOT/RECORD BUTTON to end the
recording first.
2. PRESS the BUTTON on the bottom right of the back screen,
this will open up the SETTINGS MENU. A pop up with two locks
and arrows may appear. Swipe from left to right. You may need to
PRESS the
BUTTON again.
3. PRESS the
tab on the left side of the screen. The current
section tab will be highlighted blue.
4. Scroll down the list by swiping from bottom to top until you reach
DVR MODE. You will notice there is a small box with TURN OFF
next to it. PRESS the box to activate this function. It will now say
TURN ON.
To Next Page
Loading...
Need help?
General
