INTRODUCTION
LOCATION
These cases must not be installed in the direct rays of the sun or near a source of radiant heat.
Be certain that the oor under the installation is of sufcient strength to prevent sagging. Out of level conditions will result in reduced
performance.
Wall cases (cases set with a back to a wall) and cases set back-to-back, should be positioned to allow a minimum 2-4" space behind the
back of the unit(s). This will allow necessary air to circulate behind the display case(s). Higher humidity stores with minimal air circulation
require a 4" gap.
Figure 1: Case Label Information
4 • Introduction - Location
To Next Page
Loading...
