Air system tightness inspectio
Heating filtration element
Air-condition filtration elements
- Fill in the air receiver up to the maximum pressure (600 ±
20 kPa)
- While the engine is off the minimum air-pressure
indicator must not come on during 10 minutes
Carry out a check on a daily basis before any
operation with a trailer or a semitrailer!
If pressure in the brake system drops down under
a critical limit a warning indicator on the dashboard
will come on!
NM14D039
Is placed under the bonnet in front of the cab.
After opening the bonnet, it is necessary to unscrew the
screws (2) and remove heating filtration element (1).
NM13N111
Are placed in the rear overhang of cab roof.
It is necessary to unscrew the screws (2) and remove air-
condition filtration elements (1).
NM15D093
To Next Page
Loading...
