Securing lower draw bars with CBM hooks
*Front three-point hitch
Controlling front three-point hitch
For extremely demanding working conditions
(aggregation with heavy machinery on slopes or with
aggregation side faced machines) we recommend
safely locking the hook of lower draw bar by inserting
a M8 screw to (S) hole and locking the screw with
a pad.
X901
It is designed for attachment of frontally carried
agricultural machines and implements in accordance with
ISO 8759-2.
During transport of a carried implement the
hitch must always be hydraulically locked in the lifted
osition with valves that are installed on the left side
of the tractor over the front axle.
This hydraulic lock is recommended even in case no
machine is attached to the three-point hitch.
E461
The hitch is equipped with two single acting hydraulic
cylinders which are supplied with oil from an additional
hydraulic distributor. To lift or lower, use lever (a) of the
additional distributor.
If the tractor is equipped with front three-point
hitch, use lever (a) to control it. When the front three-
oint hitch is used, quick couplers cannot be
connected as they are pressured together with the
front three-point hitch! When you finish using the
front three-point hitch and want to use the section
with quick couplers 1 and 2 with connection to the
front three-point hitch, raise the arms of the front
three-point hitch to the transport position and move
the front three-point hitch lever to the 'locked'
osition
1 position lifting
2 position lowering
N position locking the hitch
P position not to be used
NM13N019
To Next Page
Loading...
