Name: Zetor Proxima 90
Brand: Zetor
Rating: 4 (1 reviews)

To Next Page

To Previous Page

118

WHEEL TREAD CHANGE

C506

SETTING THE WHEEL TOE-IN AT TRACTORS WITHOUT FRONT DRIVING AXLE

Note: As standard, the tractors are provided with hydrostatic steering.

 Set the wheels symmetrically with the longitudinal axis of tractor.

 In the front in horizontal plane of wheel axes measure the distance between rims.

Mark the measuring point.

 Drive the tractor so that the marked points would be in the rear in horizontal plane

of wheel axes (turning by 180°) and again measure the distance between the

marked points.

 Shift out the piston rod of the cylinder at 145,5  1.

 Loosen the nuts (2,3) and by turning the rod (4) adjust the toe-in at the required

value (measure at the rime side).

 Tighten the lock nuts of the heads of ball joints by torque 122 - 136 Nm. Upper

surfaces of heads must be parallel.

Questions and Answers:

Need help?

Do you have a question about the Zetor Proxima 90 and is the answer not in the manual?

Zetor Proxima 90 Specifications

General