7
DRIVING OPERATION
P+11NG202
P+11G203
STARTING THE ENGINE
1. Put the key in ignition - ”0” position.
2. Depress the clutch pedal.
3. Move the gear lever to the neutral po-
sition.
4. Turn the key to “I“ position. The glow
plug indicator illuminates.
5. Wait till the glow plug indicator goes
out (the time depends on the tem-
perature of the liquid coolant).
If the glow plug indicator does not
illuminate but flashes, there is an
error of the ignition system (Igni-
tion system error signals chap-
ter). Have the error repaired in a
specialized service station.
6. When the indicator goes out, turn the
key immediately (do not wait for long-
er than 5 sec. at maximum) to “II“ po-
sition (start).
7. After ignition, release the key immedi-
ately, it automatically turns back to ”I”
position. Do not extend the starting
process to more than 15s.
8. After ignition, decrease the amount of
fuel gradually.
To Next Page
Loading...
Need help?
General